Broken Garage Door Spring: What to Do Right Now
Heard a bang and the door won't lift? Here is how to confirm a broken spring, why not to force the door or pull the release, and what happens next.

If you have a broken garage door spring (a loud bang, then a door that is suddenly heavy or will not lift), stop using the opener, do not force the door or pull the release handle, keep people and cars clear of the door, and call a professional. The rest of this page explains why.
How can you tell you have a broken garage door spring?
A broken spring usually announces itself: a loud bang, a door that feels far heavier than yesterday, or an opener that hums and barely moves the door. Add a visible gap in the coil above the door or slack lift cables, and you can be fairly sure. Most of these signs show up together.
Here is what we hear from homeowners and see on service calls:
- A loud bang, often from inside the house. People describe it as a gunshot or something falling in the garage. That is the spring releasing its stored energy.
- A gap in the torsion spring. The coil sits on a shaft above the door. A clean break leaves a visible gap of an inch or two between the two halves.
- A very heavy door. Chamberlain notes that a heavy door indicates a spring problem requiring professional service, and says to stop immediately if the door feels unusually heavy, will not stay open, or slams shut (Chamberlain Group support).
- An opener that strains. It hums, lifts the door a few inches, then stops or reverses.
- Loose cables or a crooked door. A slack lift cable often comes with a broken spring, and we look at the cables at the same visit.
What can look broken but is not?
Rust alone does not mean a break. A dry, rusty spring with no gap and a door that still feels balanced is worn, not failed. A disconnected opener trolley or a blocked safety sensor can also stop the door without any spring damage. Confirm by looking for the gap in the coil, not by the rust. If none of this fits, our garage door won't open guide walks through the other common causes.
Broken garage door spring symptoms: what you notice, what it means, and what to do.
| What you notice | What it usually means | Safe to do now? | Next step |
|---|---|---|---|
| Loud bang, then door feels very heavy | Torsion spring broke | Do not lift or run the opener | Leave it, call |
| Visible gap in the coil above the door | Confirmed spring break | Stay clear of the shaft | Call |
| Opener hums, door barely moves | Spring or cable failed | Stop pressing the button | Call |
| Slack cable or door tilted to one side | Cable off drum or snapped | Do not force the door | Call |
| Door rises partway and slams down | Weak or broken spring | Do not release it or stand under it | Call |
| Rusty spring, no gap, door still balanced | Wear, not a break yet | Yes, just watch it | Schedule service |
Takeaway: any bang, coil gap, or heavy door on a garage door means stop and call, while rust on a balanced door only calls for a service visit.
Sources: DASMA safety tips; Chamberlain Group support; Stucky field experience.
Is it safe to open the door with a broken spring?
No. The spring does the lifting, and the opener only guides the door along the track. With the spring gone, your arms or the motor face the full dead weight of the door. The Genie Company says not to operate the door "either manually or with the opener" when it has a broken spring (Genie support).
Why does running the opener make it worse?
The motor and drive gear are sized to move a balanced door, not to hoist one whose spring failed. Pressing the button again can strip the gear or trolley, overheat the motor, or pull a cable off its drum. That turns a spring repair into a spring-plus-opener repair, and our guide on whether to repair or replace a garage door opener covers that decision. If your opener is already aging, our opener buying guide explains what to look for later, but do not test it against a broken spring.
Why is lifting by hand risky?
A door without spring help is heavy, and it can drop without warning if your grip slips or a cable lets go. Chamberlain says that if the springs are weak or broken, the door may fall rapidly and without warning. Hands, feet, and cars are all in the path.
Should you pull the emergency release on a broken spring?
Usually not. With the door closed, the release only frees the trolley. With it open or partway up, pulling it can drop the door with nothing to slow it. Chamberlain says "NEVER pull the emergency release handle to raise or lower the door."
That is our reading of the rule for a broken torsion spring. A closed door stays closed, and an open one stays where it is until a technician secures it in the track.
What if a car is trapped in the garage?
Do not try to muscle the door up or drive through it. A trapped car is a solvable problem, and the answer is to tell the technician when you call so they arrive ready for it. In our field practice, we lift the door manually, secure it in the track, and free the car.
- Door closed, car inside: leave it closed. If the house has an entry door from the garage, use it to get in and out.
- Door stuck open: do not try to close it. Keep the area under it clear.
- Kids and pets: keep them out of the garage and away from the door's path until the door is secured.
Torsion vs extension springs: how do the failures differ?
A torsion spring sits on a shaft above the door and breaks with a bang, leaving a visible gap. An extension spring runs along the horizontal track and can whip loose when it snaps. DASMA says doors with extension springs need a safety cable running through the spring, which "can keep that broken spring contained" (DASMA).
Torsion springs are what Stucky Garage Doors finds on most doors in St. Charles, Lincoln, and Warren counties, though older homes still turn up extension springs now and then. Both types are professional repairs.
Why do pros replace both springs?
If your door has two springs, DASMA's advice is plain: "replace both, even if one is not broken" (DASMA). The two springs share a shaft and have lifted the same number of cycles, so the survivor is usually near the end of its life. A new spring beside an old one can also unbalance the door.
For the cycle math, see our torsion spring guide.
Why isn't fixing a broken spring a DIY job?
Because the stored force is real, and the failure is unforgiving. DASMA calls springs "arguably the most important and most dangerous part of your door" and says spring systems "should be repaired only by trained professionals" (DASMA). Genie tells owners not to remove, repair, or adjust springs or the parts they attach to.
Injuries are documented. A case series from Massachusetts Eye and Ear described seven patients treated over 15 years for open globe eye injuries after a garage door spring dislodged at high velocity while they were repairing their own doors. Five developed retinal detachment (Shah et al., Ophthalmic Surgery, Lasers & Imaging Retina). It is one hospital, not a national rate, but it shows what a slipped winding bar can do.
There is a second problem. DASMA's spring cycle-life data notes that an incorrect number of turns or a spring on the wrong door is "a safety issue" (DASMA TDS-190). A wrong-weight spring from a hardware store is one of the most common mistakes we see. We will not describe winding steps here, on purpose.
What happens during a professional spring replacement?
It is usually a single visit. The technician secures the door, removes the broken spring and its partner, matches new springs to the door's weight, and winds them to spec. Then they inspect cables, drums, rollers, and hardware, and run two tests: a balance test, where the door should hold mid-travel when disconnected from the opener, and a safety-reverse test.
Cost depends on your door, so we do not print numbers here. It is generally far less than a new door, and a repair visit costs less than putting off the fix and damaging the opener. For a real figure, request a quote through our contact page.
Missouri weather adds wear. The NOAA 1991-2020 normals for the St. Louis area show about 85 nights a year below freezing and about 47 days at 90 degrees or higher (NOAA NCEI). DASMA TDS-190 lists extreme heat or cold and frequent precipitation among the stresses on a door, and it says regular lubrication helps maximize spring cycle life. A yearly check, as in our service frequency guide, catches a tired spring early.
What should you do next?
Leave the door where it is, keep everyone clear, and book a repair. Larry Stuckenschneider started this company in 2018 on the idea of Honest Garage Door Repair. No Gimmicks. and that applies here: we will tell you what broke and what needs replacing, and nothing else. See our garage door repair services or contact us for a quote.
We serve homeowners across St. Charles, Lincoln, and Warren counties. Our St. Charles County page and our Wentzville page cover the local details.
Frequently Asked Questions
- Can you open a garage door with a broken spring?
- You should not. Without the spring, the door is dead weight, and the opener was never built to lift it alone. Forcing it risks a dropped door, a burned-out motor, or a cable jumping off its drum, so leave it closed and call a professional.
- How can I tell if my garage door spring is broken?
- The classic signs are a loud bang, a visible gap in the coil above the door, a door that feels suddenly heavy, and an opener that strains or lifts only a few inches. Slack cables or a crooked door point the same way. A rusty spring with no gap and a balanced door is worn, not broken.
- Is it safe to pull the emergency release with a broken spring?
- Only with the door fully closed, and only to free the opener trolley. Chamberlain warns never to pull the release to raise or lower the door, because a door with weak or broken springs may fall rapidly and without warning. If the door is open or partway up, leave the handle alone.
- Should both garage door springs be replaced if only one broke?
- Yes. DASMA advises replacing both springs on a two-spring door, even if one is not broken. Both sat on the same shaft and lifted the same number of cycles, so the survivor is usually close behind, and mismatched springs leave the door unbalanced.
- Can I fix a broken torsion spring myself?
- We strongly advise against it. Torsion springs hold a lot of stored force, and DASMA says spring systems should be repaired only by trained professionals. A one-hospital case series also documented serious eye injuries from springs that released while people repaired their own doors.
- How long does a broken spring repair take, and what does the visit involve?
- It is usually a single visit. The technician secures the door, replaces the springs, matches them to the door's weight, then checks cables, drums, rollers, balance, and the safety reverse. For a quote, use our contact page.
Need Garage Door Help?
No gimmicks, no hidden fees. You don't pay until the job is done.